Analog Design Engineer Resume Dallas, Texas - Hire IT People

SUMMARY

Expertise in design and development of analog and mixed signal electronic circuits.
Good experience in automotive domain and circuit development under ISO 26262 compliance.
Acquired knowledge at both board level and integrated circuit level designing.
Worked on end - to-end module development activities such as requirement analysis, schematic implementation, WC calculation, Monte Carlo simulation and lab verification.
Better know-how of electronic circuit designing using active and passive components.
Designed, validated power controllers such as Boost, Buck, LDO’s with feedback and compensation techniques.
Sound skill on FMEA and electrical stress analysis.

PROFESSIONAL EXPERIENCE

Confidential, Dallas, Texas

Analog Design Engineer

Responsibilities:

Worked on 28nm and 40nm RFIC circuits such as Oscillator, Ring PLLs, LC PLLs, and LDOs etc.
Carried out module design activities such as PSS and Pnoise analysis, PVT simulations, Extracted simulations, Floor planning, Constraints driven routing, Auto & Manual routing, Top-level mixed signal verification using Hierarchy editor & AMS Designer.
Cadence design environment: Virtuoso, ADE L, Spectre, Virtuoso Layout Editor L & XL (Generating clones, Constraint driven routing, Interative routing, Module generator, Floor planning), DRC, LVS, Layout extraction.
Behavioural modeling of PMW, DC-DC controllers, gate drivers and opamps etc.

Confidential

Hardware Engineer

Responsibilities:

Worked on end-to-end module development activities such as requirement analysis, schematic implementation, WC calculation, Monte Carlo simulation and lab verification.
Designed signal processing circuits for analog and digital sensor interfaces such as pressure, temperature, and hall-effect based sensors.
Worked on power converter modules such as linear regulators, DC-DC converters (Buck, Boost and Flyback), half bridge drivers, PWM controllers etc.
Worked in developing micro-controller module (MC9S12G128).
Hands on experience in circuit simulations (Monte Carlo and Worst-case) and circuit modeling using SABER and Pspice tool.
Implemented quality tools like FMEA (Failure Mode Effect Analysis), DRBFM (Design Review Based on Failure Mode), and DAR (Decision Analysis).
Strong lab and silicon validation skills. Expertise in building the required test setup, module verification, HV (High Voltage) testing and environmental testing & knowledge on EMI/EMC.
Good experience in automotive domain and circuit development under ISO 26262 compliance. Doing measurements at high switching currents in simulated electric vehicle environments.
Practice with CMMI 5.0 procedures.

Confidential

Associate Engineer

Responsibilities:

Design, Modification and Verification of Electronic Dimming Ballast.
Designed an output tank section for the required wattage of lamp.
Design validation of sub-modules such as voltage and current sensing circuits, half bridge driver, PFC, resonance tank (LC) and filament preheating current source.
Hard switching evaluation and thermal testing.

Confidential

Associate Member Technical

Responsibilities:

Board level derating & loading analysis
Calculating the power stress on individual components of schematic.
Calculating the loading on the sources such as SMPS Regulators and buck-converters.
Component Engineering: Updating & replacing the non-ROHS components.