RF Technician II / HUB Engineer/Application Engineer Resume Irvine, CA - Hire IT People

SUMMARY:

Skilled in WCDMA, LTE, CDMA and GSM
Commissioning, and troubleshooting /optimization for indoor & outdoor DAS Crown Castle
DAS integration, optimization and handover
New site build roll out, and performance improvement
Coordinator for post launch RF optimization
Trouble shooting UMTS, CDMA & LTE networks
Monitor network performance improvements for all carriers
RF optimization expert on Ericsson LTE & UMTS equipment

PROFESSIONAL EXPERIENCE:

Confidential, Irvine, CA

RF Technician II / HUB Engineer/Application Engineer

Responsibilities:

Over 10 years with DAS: integration, commission, RAN & DAS tuning and optimization
Experience and certify with DAS equipment (Tyco, Mobile Access, Commscope)
Experience in Integration, and optimization LTE & UMTS technology, network optimisation including (capacity management, Radio coverage shaping, increase cell throughput, service accessibility, Layer and Load management, parameters tuning)
Process data using Mapinfo, ChamelCW, Link Master LML/LMA, WindCatcher+/Xceed Technologies, ACT Analyzer, Atoll, Actix, Google Earth Pro, iBwave solution, and Viavi Solution,
Pre and post launch tuning, troubleshooting, and optimization for RAN and indoor/outdoor DAS
RBS and DAS equipment faults diagnosis, alarms analysis, and perform field troubleshooting on RBS, DAS and antenna system
Collect and process data pre and post site launch
Assisting with the selection of the sites
Performing CW Testing, and processing data to repot accurate selection

Confidential, Irvine, CA

Optimization Specialist (contractor)

Responsibilities:

Collect and process RF field data to help bring new sites on-air
Collect and process systems baseline data to help troubleshoot drop-call and block-call problem areas
Perform in-building coverage service analysis
Interacted directly RF Engineers, Technicians and management
Utilized Engineering tools to monitor, evaluate, record, and report major outages. Experience with mapping programs (MapInfo, MS Streets and Trips, etc.)
Collected CW measurements in support of new site candidate evaluation
Set-up and operate a CW transmitter and receiver including configuring antennas, cables, connectors and drive a specified data collection route
Verified site contacts and plans are in place for site testing. Post process and analyze CW measurement date
Perform site audits. Accurately determine antenna azimuths, down-tilts, antenna types
Determine if new sites are functioning properly during the initial baseline process and whether or not the new sites should remain on air and get handed over to RF Engineers for further RF optimization and traffic data analysis

Confidential

Admissions Advisor

Responsibilities:

Conduct an average of 80 phone interviews a day to screen initial questions from potential student applicants
Conduct personal interviews to qualify candidates and to explain Bryman’s academic programs
Complete the student qualification process to determine their eligibility for admission
Solicit referrals from prospective candidates to provide a positive flow of student applicants; diligently follow all leads in order to fill PD quotas and lead workage percentages
Apply the fundamental concepts, practices and procedures of the Department of Enrollment Management
Consistently met weekly and monthly application target and enrollment quotas
Act in a liaison capacity with other departments to ensure proper student enrollment

Confidential, Burbank, CA

CW Test Technician (contractor)

Responsibilities:

Performed production testing for CW and RF characterization of specific devices
Aligned, tested, and troubleshoot RF/Microwave receivers, converters and switches
Verified Antenna Placement to identify proper operation for wireless communication
Assisted with Site Construction Management
Evaluated the job site to ensure proper signaling and communication between receivers and transmitters
Familiar with current and next generation multiple access technologies
Maintained test records, calibration data, and documentation required by production test procedures