Objective:Seeking a Engineering Challenging and Technical Position in the field of Telecommunications.
Fifteen years of experience in the Telecommunications field, hardworking, self-motivated and can work independently.

Employment:

4/2008 – Present, Confidential
    

• Title RF Engineering and  Base Station Antennas   
• Skill in operating various mechanical and electrical testing devices and tools preferred. Examples of equipment include, but are not limited to, Power Meter, Service Monitor, Transmission Test Set, Spectrum Analyzer, Volt/Amp Meter, Site Master Sweep Gear and  Path A
• Skill in operating Windows based computer.
• Ability to prioritize projects and work independently
• Night, weekend and holiday on-call duty as required
• Available in emergency situations via mobile phone or pager to restore site operations on a 24/7 basis

10/2007 – Present, Confidential,
                                               
The ideal candidate should have experience in RF Engineering, with an emphasis on systems engineering and UNIX Review of daily work orders and MOP with crew to verify daily work schedules. 

• Preparation and loading of inventory for work vehicle to ensure necessary supplies are available.
• Installation of 4G site Reconfigurations for Sprint/Nextel from 800 to 900 MHZ, running power, ground and timing (Ethernet & 5 MHZ), upgrade hard line jumpers from In to Din, upgrade Polyphazers on usage of Amritzu S332D meters, perform line sweeps on all new antennas and sector lines,4G sites Telco audit and upgrades for Sprint/Nextel; running and termination of (2) 25 pairs cables for T1 or DS3 depending on Sprint/Nextel requirements.
• Completion and submission of daily job site logs via email transmission.

05/2005 - 10/200, Confidential,
:                                                                             
Position:                        Senior Base Transceiver System Tech. BTS Tech
Responsibilities:         

• Upgraded and performed routine maintenance on Sprint/Nextel Integrated Digital Enhanced Network (IDEN) 800 and 900 megahertz radio equipment. 
• Responsibilities included replacing and upgrading of the Gen 4 and Pre-Gen 4 “wide band” duplexers and the Integrated Site Controller (ISC2). This task required knowledge and experience in the reconfiguration of the rack and other components to accommodate the newer smaller ISC3 controller.  The task also required the reroutes of both the Ethernet and 5 megahertz cables to all sectors in that site’s configuration. Upon completion of the upgrade task, ran tests, verified the program downloads, and ensured the upgraded system was back up on the air and operating without fault.
• I performed all of above tasks with technical precision, little supervisions and less than allowed downtime.

03/2004 – 05/2005, Confidential,                                       

Position:                      Wireless Cell Site Installation Supervisor.
Responsibilities:         

• Leader of the 2-member team
• Install True Position LMU and run cable for Alpha, Beta, and Gamma sectors of Nortel BTS/Ericson RBS to LMU as well as T1 cable from CSU.  Path Master and turn up power.
• Install and run cable for both GPS and Downlink to LMU.             
• Perform commissioning of LMU initialization, GPS status, GPS antenna coordinate entering, bit enabling, all port testing, and Downlink verification according to1900Mhz band.
• Coordinate with switch tech for testing LMU communication.
• Familiar with Ericson, Nortel S8000, S12000, Nokia Ultrasite, & Seimens BTS
• Experience with CDMA, TDMA, GSM, Radios, NIU, & T1
• Commission cell site equipment & perform radio add-ons
• Knowledge of Arnritsu sweep test & Andrews Comscope Connectors
• Perform various type of site surveys for T-mobile & Cingular

05/1998 – 03/2004, Confidential,                                  

Position:                      Installation Technician
Responsibilities:

• Network Installations for QWEST, equipment such as OC192, OC-12, DMF, T1, BDFB, DS1, DS3, DS0, CISCO, and Sonas Soft Switch (FSP).
• Wired, wire wrapped, and made B&C connecting, alarm cable, ran and cleaned Fiber, ran and tested cat 5, turned up power to test.
• Network equipment such as lite pan 2000, MDF, BDFB, DS1, DS3, Tested all the cable, and turned up power.

12/1997 – 05/1998, Confidential,
                             

Position:                      Installation Technician
Responsibilities:

• Network Installation for Acatel (DSC) OC-3, OC-12, OC-48, ran Fiber optic cable, clean Fiber, DSL, DS-3, and put in life pan 2000.
• Network Operation Engineer III -Responsible for certification and verification of new generic software loads and hardware upgrades for Acatel (DSC) Megahub DEX 600E Lucent Switch.
• Supported and maintained the FT-Unix base computer (MSP) used to download Bulkani translation and check all database and build database for all ISDN and Daplink SS7 for data crunching. Do all Ericsson AXE 10 BYB 501 Responsible troubleshooting Trunk Maintenance, Group Switch tester APZ, Signaling c.c.s 7, Subscriber, test TDMA and GSM. Test and turn up system

04/1996 – 11/1997, Confidential,
                                               

Position:                     Technician
Responsibilities:
Work that included cabling, wiring, wire wrapping, survey, verifying, connecting, and all turn up of power on the following telecommunication devices:

• Data Service Bay
• Broadband DXC
• Wideband DXC.
• Work that included cabling, wiring, wire wrapping, survey, verifying, connecting, and all turn up of power

05/1995 – 04/1996, Confidential,
       

Position:                     Network Installer
Responsibilities:

• Responsible for Installing, Cabling, Wiring, and Wire wrapping.
• Turn up of power, and performed installation testing.
• Work that involved telecommunications equipment such as Wideband DXC, DSC, equipment DTX, DSH, Northern Telecommunications.

04/1993 – 05/1995, Confidential,
           
Position:                      Field Technician
Responsibilities:

• Responsible for installing cables.
• Troubleshooting PCB
•  Installed soldering through hole diodes, resistors, and capacitors.
•  Responsible for IC’s related to Surface Mounting.

EDUCATION:         
Associate of Applied Science Degree in Computer Information Systems 1993
CERTIFICATIONS:
True Position LMU & WiMax (4G) Certified.