Test Engineer Resume
5.00/5 (Submit Your Rating)
NJ
OBJECTIVE
A professional position in RF/signal integrity
SKILLS AND ABILITIES
- Microwave RF circuit design using ADS
- PCB layout design using ADS, PROTEL, HFSS
- Digital signal processing using MATLAB
- operating oscilloscopes, VNA(vector network analyzer), multimeters
- High-speed circuit signal integrity analysis using ADS, HFSS, H-Spice
- Programming skills: MATLAB, C#, 80x86
EDUCATION
- Master of science
- Bachelor of engineering
RESEARCH EXPERIENCE
The design and analysis of an active integrated antenna (Master thesis)
- A microstrip patch antenna is designed and simulated by the inset feeding method.
- A LNA (low-noise amplifier), composed of NE68030 NPN silicon transistor, bias circuit, and noise matching network, is also studied and designed.
- The microstrip patch antenna and the LNA are integrated together in both the schematic circuit and layout circuits.
Differential Signaling Analysis of Serial ATA Connection
- Differential PCB trace/cable/connector modeling and analysis using HFSS
- Serial ATA connection loss and jitter analysis based on S-parameters and eye diagrams
- Serial ATA connection TDR impedance simulation using Agilent ADS
Receiver front end for automatic sensor system
- Designed a system which transferring the analog signal into digital signal (including amplifier, sample holder, A/D converter)
- Draw circuit with Protel and fabricated it on PCB board
- Run test on PCB board using MCU and C# code
Designed a microstrip dipole antenna for RFID device using ADS
- PCB layout design, tuning using ADS/Momentum
- Device selection, stability design, Smith chart impedance matching
Control system simulation using MATLAB_SIMULINK
- Closed loop feedback system modeling and programming
- PID controller simulation and analysis
IBM PC I/O circuit analysis
- Run test program using assembly language
- Use oscilloscope to test the I/O connector
EMPLOYMENT HISTORY
Test Engineer Jan 2008-Jul 2009
Confidential,Guangzhou, China
